18-18 WD 2/ WD 2M
9 Fault messages and fault elimination
Message/Symptom Possible cause Corrective measures
Display: "- - -“
− Tool has not been detected
− Tool defective
− Check connection of tool to device
− Check connected tool
Display: "tip" Soldering tip of microtool not
correctly inserted or defective
− Insert soldering tip again
− Replacing defective soldering tip
No display function
(display off)
No mains supply voltage
− Turn on mains power switch
− Check mains supply voltage
− Check device fuse
10 Accessories
T005 13 173 99 WMRT Desoldering set
T005 27 028 99 Preheating plate WHP 80 (for WD 2M only)
T005 29 178 99 WSP 80 Soldering iron set
T005 29 179 99 WMP Soldering iron set
T005 31 185 99 USB Extension module
T005 29 188 99 Soldering iron set LR 82
T005 33 131 99 MPR 80 Soldering iron set
T005 33 133 99 WTA 50 Desoldering set
T005 29 189 99 WSP 150 Soldering iron set
T005 15 156 99 WMRH soldering iron holder for WMRP
T005 29 183 99 Soldering iron holder WMRH (for WD 2M only)
T005 15 161 99 WDH 10T safety stand
with "Stop & Go" function for WSP80/WP 80
T005 15 162 99 WDH 20T safety stand
with "Stop & Go" function for WMP
T005 15 146 99 safety stand with "Stop & Go" function WMRT
T005 29 181 99 Soldering iron set WP 80
T005 87 597 28 Reset connector °C
T005 87 597 27 Reset connector °F
Please refer to the operating instructions accompanying the
individual soldering iron sets for more information on accessories.
11 Disposal
Dispose of replaced equipment parts, filters or old devices in
accordance with the rules and regulations applicable in your country.
12 Warranty
Claims based on defects will fall under the statute of limitations
12 months after delivery to the purchaser of the goods. This shall not
apply to rights of recourse of the purchaser according to sections
478, 479 German Civil Code.
We shall only be liable arising from a warranty furnished by us if the
quality or durability warranty has been furnished by use in writing
and using the term "Warranty“.
Subject to technical alterations and amendments! See the updated
operating instructions at www.weller.eu.
To Next Page
Loading...
