OPTIONAL ACCESSORIES IN.CLEAR IN SMART TOUCH
TROUBLESHOOTING
NO FLOW CONDITION
(OUT OF DIAGNOSTIC MODE)
With the linked version, this message
appears when the in.clear's pressostat
is open for longer than 3 minutes
and the pump associated with it was
activated by the hot tub pack.
Verify that the in.clear unit was installed
on the right pump (must be installed on
the circulation pump if present).
Check that the in.clear is installed on
the pressure side of the pump and that
water is flowing through the in.clear
unit.
COMMUNICATION ERROR
The lost communication error indicates
that a linked version of the in.clear
is being used, but a pack cannot be
detected. Ensure that you are using
a compatible pack with appropriate
software, and that all connections are
secure. If this does not clear the mes-
sage, contact your dealer for help.
LOW OR NO BROMINE READING
Make sure the maintenance level is properly set according
to the procedure described in the section Set Maintenance
Level. Make sure there is no error or warning message on
the display, the cell is activated and that water is circulating
properly through the cell.
Make sure water chemistry is balanced. Refer to the section
Adjust Water Chemistry in the Hot tub for more details.
Test your hot tub water for phosphate to make sure there
is no contamination. Phosphates should never exceed 100
PPB. Phosphates can be introduced to your hot tub water by
household cleaners, soaps and lotions.
Change your filter or clean it with a filter cleaner and rinse
thouroughly with cold water.
Make sure the in.clear cell is not damaged and that no calci-
um or lime deposits appear on the cell plates. Clean your cell
regularly (at least once a year).
LONG RECOVERY TIME AFTER USAGE
Activate Boost Mode at the appropriate level every time you
use your hot tub. Refer to the section Determine the Boost
Level.
Heavy bather loads will require longer boost periods. If
bromine level is below 3 PPM following a boost period, re-ac-
tivate Boost Mode to bring the bromine bank within 3-5 PPM.
The bromine bank should always be regenerated following
a boost period. If a high boost level does not regenerate the
bromine bank properly, increase the daily filtration time.
If bromine production is still inadequate after following all
of the instructions above, biofilm deposits could be causing
the lack of bromine generation. Flushing products such
as Sea Klear Hot tub System Flush, Swirl Away or National
Chemistry Hot tub Purge have shown to be effective for
biofilm removal.
94
To Next Page
Loading...
