18
NO ICE TROUBLESHOOTING
1. Is there any Push Button LED blinking?
A. ICE push Button is blinking when Auger Motor doesn’t operate properly.
B. WATER push Button is blinking when there is no water has been supplied.
2. If there is no blinking, reset the system, by unplugging the power plug for 10 sec.
3. If the unit does not start making ice, Disassemble the TOP COVER, TRAY & FRONT COVER.
A. Remove the ICE & WATER Dispenser Deco
B. Remove the TOP COVER by removing the 2 screws located at the back
C. After removing the tray, remove the 2 screws on the bottom then remove the FRONT PANEL.
4. Verify the water level inside the water reservoir.
A. If the water level is below the LOW WATER LEVEL SENSOR, then check the water supply
5. Assemble the FRONT PANEL and wait for 5 min.
A. If the FRONT PANEL is not attached to the system, Ice-making operation won’t work.
(COVER SWITCH needed to be pressed.)
B. 5 min after re-plugging the system, the ICE AUGER will restart by rotating
C. Additional 1 min would be necessary before Compressor and Fans operate properly.
To Next Page
Loading...