Wellue BP2 - Using the Monitor; Charging the Device Battery; Blood Pressure Measurement Procedure

8
3. Using the Monitor
3.1 Charge the Battery
Use the USB cable to charge the monitor. Connect the
USB cable to a USB charger or to the PC. A fully charge
will need 2 hours. When the battery charged fully the
indicator will be blue.
The monitor works in a very low power consumption
and a full charge usually works for months. A battery
symbols which indicate the battery status is displayed
on the screen.
Note: The device cannot be used during charging.
3.2 Blood Pressure Measurement
3.2.1 Before Taking a Measurement
To help ensure an accurate measurement, follow these
directions:
 Rest for at least 5 minutes before taking the
measurement.
 Stress raises blood pressure. Avoid taking measurements
during stressful times.
 Remove tight-fitting clothing from your arm.
 A single measurement does not provide an accurate
indication of your true blood pressure. You need to take
and record several results over a period of time.
 Try to measure your blood pressure at the same time
each day for consistency.
3.2.2 Applying the Arm Cuff
1. Wrap the cuff around the upper arm, about 1 to 2
cm above the inside of the elbow, as shown.
2. Place the cuff directly against the skin, as clothing