PROBLEM CAUSE SOLUTION
Jammed fastener.
1. Incorrect fastener has been loaded.
1. Load fasteners with the correct spec-
ifications for this tool.
2. Low battery charge or damaged battery. 2. Charge or replace the battery.
3. Debris in the nose piece.
3. Clean the nose piece with pneumatic
air tool oil and a clean cloth.
4. Debris in the magazine.
4. Clean the magazine with pneumatic
air tool oil and a clean cloth.
5. Worn magazine.
5. Contact customer service at 1-847-
429-9263.
6. Worn or damaged pusher spring.
6. Contact customer service at 1-847-
429-9263.
TROUBLESHOOTING GUIDE
WARNING! Stop using the tool immediately if any of the following problems occur. Repairs and replace-
ments should only be performed by an authorized technician. For any questions, please contact our customer
service at 1-847-429-9263, M-F 8-5 CST or email us at techsupport@wenproducts.com.
16
To Next Page
Loading...
Need help?
General
