MAINTENANCE
CLEANING
Keep tools clean for better and safer performance. Wipe the tool clean with a damp towel and mild soap. Blow the
tool clean using compressed air, then use non-flammable cleaning solutions to wipe exterior of the tool as neces-
sary. Do not soak tool with cleaning solutions. Such solutions can damage internal parts.
INSPECTION
1. Inspect trigger and safety mechanism to assure system is complete and functional (no loose or missing parts, no
binding or sticking parts). Do not operate if any portion of the tool, trigger, or nose is damaged, inoperable, discon-
nected, or altered. Damaged or missing parts should be repaired or replaced before use.
2. Keep all screws tight. Loose screws can cause personal injury or damage the tool.
STORAGE
Store the unit and accessories in a dark, dry, frost-free and well ventilated place, out of the reach of children. The
ideal storage temperature is between 50 to 86 °F (10 and 30 °C).
WARNING! To avoid injury from accidental startups, make sure that the tool is OFF and the battery is re-
moved when performing any maintenance.
OPERATION
THE FIRING CONTACT PIN & NO-MAR TIP
Routinely check the condition of the firing contact pin
(Fig. 8 - 1) before each use. The firing contact pin must
not be restricted in any way in order for the tool to oper-
ate properly. The spring must return the firing contact
pin to its fully extended position after being depressed.
DO NOT operate the tool if any part of the firing contact
pin is not operational.
The no-mar tip is attached the nose of the nailer to pre-
vent marring or possible denting when working with
softer materials. One replacement no-mar tip has been
included as an accessory. Replace the worn no-mar tip
when necessary.
Fig. 8
1
14
To Next Page
Loading...
Need help?
General
