9
MAINTENANCE
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the trigger is in the “O” off-position and unplug the tool from its electrical outlet before
performing any procedure in this section. Do not use damaged equipment. If abnormal noise or vibra-
tion occurs, have the problem corrected before further use.
To prevent serious injury from tool failure:
1. Inspect the general condition of the tool before using. Check for loose screws, misalignment or binding of
moving parts, cracks, damaged electrical wiring, etc. The sanding paper should not be dull or contain excessive
debris build-up. The scraper blade and saw blade should be clean and sharp.
2. After use, clean external surfaces of the tool and the attachments with a clean cloth.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualied
service technician.
GENERAL OPERATING INSTRUCTIONS
1. This tool works by oscillating rapidly. You should not force or over-
exert the tool. Allow the tool to cut or do its job in order to get the best
possible performance.
2. Attachments may be mounted at angles up to 90° left or right. The
attachment should not turn on the spindle. If it does, make sure that the
cap screw is tight. Note: The long saw blade should only be used in the
straight ahead position (Figure 2).
3. Retract the power switch to its off position. Connect the tool into the
nearest 120 volt, grounded electrical outlet.
4. To turn on the tool, slide the Power Switch forward.
5. Adjust the speed of the tool using the speed dial. There are six speed divisions from 1 (slowest) to 6 (fastest).
6. Do not allow contact between the accessory attachment and the work piece until the tool is running at full
speed.
7. Avoid contact with foreign objects such as metal screws and nails when sanding, scraping, or cutting.
8. Do not apply excessive pressure on the tool.
9. When finished, turn off the tool and allow it to completely stop before setting it down. Then unplug the tool
from its electrical outlet.
10. To replace the sanding paper, simply pull it off the pad. Prior to storing the tool, remove the attachment and
wipe it clean. Store the tool in a clean, dry, safe location out of reach of children and other unauthorized persons.
OPERATING INSTRUCTIONS
To Next Page
Loading...
Need help?
General
