4
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant rubber-soled foot-
wear. Keep the floor clear of oil, scrap, and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow instruc-
tions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage, improper
mounting, or any other conditions that may affect the tool’s operation. Any part that is damaged should be properly
repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS remove start-
er keys.
19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that may affect your
ability to properly use the tool.
20. USE SAFETY GOGGLES AT ALL TIMES that comply with ANSI Z87.1. Normal safety glasses only have
impact resistant lenses and are not designed for safety. Wear a face or dust mask when working in a dusty environ-
ment. Use ear protection such as plugs or muffs during extended periods of operation.
GENERAL SAFETY RULES
1. This lathe is designed and intended for use by properly trained and experienced personnel only. If you are not
familiar with the proper and safe operation of a lathe, do not use it until proper training and knowledge have been
acquired.
2. Always wear eye protection and a face shield/dust mask when using the lathe.
3. Make sure all tools, chisels and accessories are sharp enough for the task at hand before using them. Always use
the right tool at the correct speed and feed rate.
4. Turn off and unplug the machine before doing any cleaning or maintenance. Use a brush or compressed air to
remove chips or debris. Never use your hands to remove excess material and debris.
5. Check the workpiece carefully for splits, knots, nails, or other obstructions. These types of blemishes may cause
a safety risk during turning.
6. Adjust the tool rest to the proper height and position for the task at hand. Rotate the workpiece by hand to check
clearance with the tool rest before turning the machine on.
7. Select the appropriate speed for the task at hand. Start at a low speed and allow the lathe to ramp up to the operat-
ing speed before engaging any chisels, tools or other carving accessories.
8. Never apply coolants or water to a spinning workpiece. Never stop a rotating workpiece with your hand.
10. If gluing up a workpiece, always use a high quality glue that meets the needs of the particular workpiece.
11. Rough cut the workpiece to the finished shape before attaching a workpiece to the faceplate. When turning
between centers, make sure the headstock and tailstock are tight and snug against the workpiece.
SPECIFIC RULES FOR WOOD LATHES
To Next Page
Loading...
Need help?
General
