4
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant rubber-soled foot-
wear. Keep the floor clear of oil, scrap, and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow instruc-
tions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage, improper
mounting, or any other conditions that may affect the tool’s operation. Any part that is damaged should be properly
repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS remove start-
er keys.
19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that may affect your
ability to properly use the tool.
20. USE SAFETY GOGGLES AT ALL TIMES that comply with ANSI Z87.1. Normal safety glasses only have
impact resistant lenses and are not designed for safety. Wear a face or dust mask when working in a dusty environ-
ment. Use ear protection such as plugs or muffs during extended periods of operation.
21. DO NOT USE THE TOOL if the power switch does not turn on and off.
22. KEEP CUTTING EDGES SHARP AND CLEAN. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
23. ONLY USE ACCESSORIES AND BITS rated for operation with this particular tool.
24. MAKE SURE TO KEEP CORDS OUT OF THE WAY OF THE CUTTING PATH.
GENERAL SAFETY RULES
To Next Page
Loading...
Need help?
General
