5. Regularly turn off the machine and clear processed
material from the discharge zone. Buildup near the dis-
charge zone may prevent proper discharge and can re-
sult in kickback of material through the hopper.
6. Turn off the shredder and disconnect it from the pow-
er supply before you leave the work area. The blades
will continue to rotate for a few seconds after the unit
is turned off.
7. If the cutting mechanism strikes a foreign object or if
the shredder starts making any unusual noise or vibra-
tion, turn the unit off and allow it to come to a complete
stop. Disconnect from the power supply and inspect the
unit for damage. Check for any loose parts and tighten
them as necessary.
8. Should any component of your shredder be missing/
damaged or fail in any way, shut off the switch and re-
move the plug from power supply outlet. Have a certi-
fied technician replace the missing, damaged, or failed
parts using only identical replacement parts before re-
suming operation.
9. If the shredder becomes clogged, turn off the shred-
der and disconnect it from power supply. Wait for the
blades to come to a complete stop before clearing de-
bris.
10. Maintain the shredder with care. Keep the cutting
edges sharp and clean to ensure optimal performance
and reduce the risk of injury.
SPECIFIC RULES FOR YOUR SHREDDER
WARNING! Do not operate the power tool until you have read and understood the following instructions
and the warning labels.
7
ELECTRICAL INFORMATION
IMPORTANT: Servicing a double-insulated product requires extreme care and knowledge of the system, and should
be done only by qualified service personnel using identical replacement parts. Always use original factory replace-
ment parts when servicing.
1. Polarized Plugs. To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than
the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not modify the machine plug
or the extension cord in any way.
2. Ground fault circuit interrupter protection (GFCI) should be provided on the circuit or outlet used for this power
tool to reduce the risk of electric shock.
3. Service and repair. To avoid danger, electrical appliances must only be repaired by qualified service technician
using original replacement parts.
DOUBLE-INSULATED TOOLS
The tool’s electrical system is double insulated where two systems of insulation are provided. This
eliminates the need for the usual three-wire grounded power cord. Double insulated tools do not need
to be grounded, nor should a means for grounding be added to the product. All exposed metal parts
are isolated from the internal metal motor components with protecting insulation.
To Next Page
Loading...
General