13
ROUTINE INSPECTION
Before each use, inspect the general condition of the
tool. If any of these following conditions exist, do not
use until parts are replaced or the tool is properly re-
paired.
Check for:
• Loose hardware,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation.
CLEANING & STORAGE
1. Keep the ventilation openings free from dust and de-
bris to prevent the motor from overheating.
2. Use a vacuum or low-pressure compressed air to
remove dust and debris from the tool surfaces, motor
housing and work area.
3. Wipe the tool surfaces clean with a soft cloth or
brush. Make sure water does not get into the tool.
MAINTENANCE
WARNING! To avoid accidents, turn OFF and unplug the tool from the electrical outlet before cleaning,
adjusting, or performing any maintenance work.
WARNING! Wear protective gloves to protect
your hands. Cutting blades have sharp edges on
both sides and are fragile. Handle the blades careful-
ly to avoid personal injury or damage to the blades.
CAUTION! Most plastics are susceptible to damage
from various types of commercial solvents. Do not
use any solvents or cleaning products that could
damage the plastic parts. Some of these include but
are not limited to: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, and household deter-
gents that contain ammonia.
To clean the inside of the unit, turn the hopper locking
knob counterclockwise, and open the hopper. Clean the
cutting blades and the discharge area. Remove wood
sticks or objects that may clog the blades. Check the
blades for damage and replace if they show signs of
wear. Replace the hopper and lock the hopper locking
knob by turning it clockwise.
4. Store the tool in a clean and dry place away from the
reach of children. Store in temperatures between 41° to
86°F.
5. Cover the tool in order to protect it from dust and
moisture. It is preferable to store it in its original pack-
aging with the instruction manual and all accessories.
PRODUCT DISPOSAL
Used power tools should not be disposed of together
with household waste. This product contains electronic
components that should be recycled. Please take this
product to your local recycling facility for responsible
disposal and to minimize its environmental impact.
Please recycle the packaging and
electronic components where facilities
exist.
REPLACING CUTTING BLADES
The shredder comes with two cutting blades pre-
installed that can be reversed or replaced to keep the
cutting edges sharp. The two blades should always be
reversed or replaced as a matched set.
It is recommended to replace/reverse the blades when
the wood sticks can not be automatically drawn into the
shredder after entering the hopper. One set of sharp
edges can cut approximately 400 lbs of materials, de-
pending on the hardness and quality of the sticks. When
the cutting capacity is reached, make sure to replace/
reverse the shredder blades to maintain optimal perfor-
mance.
TIP: Replacement blades (Part No. 41121B) can be
ordered in 2-packs at wenproducts.com. These are
wear-out parts and therefore not covered under the
warranty.
Instructions continue on the next page.
To Next Page
Loading...
General