ROUTINE INSPECTION
Before each use, inspect the general condition of the tool. If any of these following conditions exist, do not
use until parts are replaced.
CHECK FOR:
• Loose hardware or improper mounting,
• Misalignment
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation
CAUTION: Most plastics are susceptible to damage from various types of commercial solvents. Do
not use any solvents or cleaning products that could damage the plastic parts. Some of these include
but are not limited to: gasoline, carbon tetrachloride, chlorinated cleaning solvents, and household
detergents that contain ammonia.
CLEANING & STORAGE
1. After every operation, use a vacuum to remove sawdust or metal shavings from the tool surfaces, motor
housing and work area. Keep the ventilation openings free from dust and debris to prevent the motor from
overheating.
2. Wipe the tool surfaces clean with a soft cloth or brush. Make sure water does not get into the tool.
3. Apply a light coat of paste wax to the column and table to help keep these surfaces clean and rust free.
4. Store the tool in a clean and dry place away from the reach of children.
LUBRICATION
The ball bearings in the spindle and the V-belt pulley assembly are greased and permanently sealed, and
require no lubrication. Pull the spindle down and oil the quill moderately every three months. Periodically
lubricate the motor pulley and motor shaft to avoid excessive vibration or speed adjustment failure.
Lubricate the table bracket and locking knobs if they become difficult to use.
PRODUCT DISPOSAL
Used power tools should not be disposed of together with household waste. This product contains
electronic components that should be recycled. Please take this product to your local recycling facility for
responsible disposal and to minimize its environmental impact.
21
WARNING:
To avoid accidents, turn OFF and unplug the tool from the electrical
outlet before cleaning, adjusting, or performing any maintenance or lubrication work.
WARNING: Any attempt to repair or replace electrical parts on this tool may be hazardous.
Servicing of the tool must be performed by a qualified technician. When servicing, use only
identical WEN replacement parts. Use of other parts may be hazardous or induce product failure.
MAINTENANCE
To Next Page
Loading...
Need help?
General
