1. TOOL PURPOSE. This drill press is designed to drill through metal wood, plastic, and tiles. Drilling
through other materials could result in fire, injury, or damage to the workpiece. Using the machine for any
other purpose for which it is not designed may result in serious injuries, machine damage and voiding of
the warranty.
2. MACHINE MOUNTING. For operation safety, the drill press must be securely mounted onto a flat and
stable surface or stand.
3. PERSONAL SAFETY.
• Always wear ANSI Z87.1-approved glasses with side shields, hearing protection and a dust mask.
• Do not wear loose clothing or jewelry, as they might get drawn in by the tool. Tie back long hair.
• DO NOT wear gloves while operating this machine.
4. Electric Cords. Keep cords away from heat, oil, sharp edges, and moving parts of the tool. Have an
electrician replace or repair damaged or worn cords immediately.
5. TOOL & ACCESSORIES INSPECTION. Before operation, check the tool and accessories for any damage
or missing parts. Do not use the tool if any part is missing or damaged. Make sure all adjustments are
correct and all connections are tight. Keep all guards in place.
6. DRILLING ACCESSORIES.
• Make sure the drill bit is not damaged before use; only use undamaged drill bits
• Make sure the drill bit is securely locked in the chuck before turning ON.
• Make sure the chuck key is removed from the chuck before turning ON.
• Use clamps or a vise (sold seperately to secure a workpiece to the table. This will prevent the workpiece
from rotating with the drill bit.
7. Make sure the table lock is tightened before starting the drill press.
8. WORKPIECE REQUIREMENTS.
• Only stand workpieces sturdy enough to withstand the force of the drill bit.
• Inspect the workpiece for imperfections, nails, staples, etc. before drilling. Never drill stock that has
questionable imperfections or embedded foreign objects.
• Do not drill materials without a flat surface unless a suitable support is used (clamp or vise).
9. PREVENTING ACCIDENTAL STARTING. Make sure the power switch is in the OFF position prior to
plugging in the machine. Always make sure the power switch is in the OFF position and the machine is
unplugged when doing any cleaning, assembly, setup operations, or when not in use.
10. Do not operate this tool until it is completely assembled and installed according to the instructions.
11. Remove scrap pieces and other objects from the table before turning ON the drill press.
6
WARNING:
Do not let comfort or familiarity with the product replace strict adherence to
product safety rules. Failure to follow the safety instructions may result in serious personal injury.
DRILL PRESS SAFETY WARNINGS
To Next Page
Loading...
Need help?
General
