88
ASSEMBLY AND ADJUSTMENTS
UNPACKING (Fig. 2)
Unpack the drill press and all of its parts. Compare against the list below. Do not discard the carton or any
packaging until the drill press is completely assembled.
To protect the drill press from moisture, a protective coating has been applied to the machine’s surfaces. Remove
this coating with a soft cloth moistened with kerosene or WD-40®. Do not use acetone, gasoline, or lacquer
thinner to clean. Apply a coat of good paste wax to the table and column. Wipe all parts with a clean dry cloth.
A
B
C
D
E
F
G
H
I
Head/Motor Assembly
Column Assembly
Table
Base
Chuck Arbor
Chuck
Extension Wing with Integrated rollers
Chuck Key
Wing Knobs (2)
J
K
L
M
N
O
P
Q
R
Table Lock Handles (2)
Hex Head Bolts (4)
Table Crank Handle
Hex Keys
Feed Handles (3)
Clamo Assembly Pack
LED Bulb
Wedge
Speed Handles
Fig. 2
To Next Page
Loading...
Need help?
General
