4214 WENPRODUCTS.COM
Assembly
and
adjustments
(continued)
WARNING: Disconnect the drill press from the power source before replacing the belt.
Replace the belt (Fig. 21)
Belt tension and drill press speed is controlled by
automatic adjustments made to the diameter of the front
spindle when the drive handle is moved.
Note: See page 23 for information on the variable speed
function of this drill press.
Remove the screw that secures the housing cover (1).
Open the housing cover.
Remove the belt (2) from the housing cover if it is
broken. If it is not broken, but is too stretched to
operate correctly, work the belt off the drive (motor)
spindle (3). Then remove the belt from the front
spindle (4).
Replace the belt by putting a new belt over the
Fig. 21
1
3
4
2
front spindle (4) and carefully sliding the belt over the drive (motor) spindle (3).
WARNING: Do not change the drive speed when the drill press is turned off.
Install the clamp assembly (Fig. 22)
1. Place the two metal squares (1) of the clamp
assembly into two corners of the table and align
the tapered edge of the squares with the grooves.
2. Align the long slots on the base of the clamp over the
openings in the metal squares.
3. Place a washer (2) over the threaded end of each lock
handle (3). Insert the lock handles into the metal
squares. Tighten handles loosely.
4. Position the clamp as needed on the table and fully
tighten the lock handles to secure the clamp.
5. Loosen the wing nut (4) to move the small support
on the front of the clamp into position. Tighten the
wing nut to secure.
Fig. 22
3
4
1
2
1
To Next Page
Loading...
Need help?
General
