LUBRICATION
This tool requires lubrication before each use (especially
the first use). If an in-line oiler is used, manual lubrication
through the air inlet is not required.
NOTE: the work surface can become damaged by excessive
lubrication. Proper lubrication is the owner’s responsibility.
Failure to lubricate the tool properly will drastically shorten
the life of the tool and void the warranty.
1. Disconnect the air supply from the tool to add lubricant.
2. Turn the tool so the air inlet is facing up. Place 4-5
drops of 30W non-detergent air tool oil (included) into the
air inlet.
3. After adding oil, run tool briefly. Wipe off any excess oil
from the exhaust.
OPERATION
RECOMMENDED HOOKUP
Your stapler is fully assembled when you receive it. Before using it, attach the air line and desired air
system accessories. See below for the recommended accessories and connection order. Be sure the
air hose is depressurized when installing or removing adapters to the air line.
OPERATING AIR PRESSURE: 70-100 psi
Select the operating air pressure within this range for best tool performance.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
9
Fig. 1
Fig. 2
0
20
40
60
80
100
120
140
160
To Air Tool Quick Connector Quick Coupler
To Compressor
Regulator
Lubricator Filter
To Next Page
Loading...
Need help?
General
