7
17. USE THE CORRECT AIR CONNECTOR. The connector on the tool must not hold
pressure when the air supply is disconnected. If the wrong fitting is used, the tool can be
charged with air after being disconnected and still be able to drive a fastener.
18. WHEN CONNECTING THE AIR. The tool can possibly fire the fasteners. Therefore,
remove all the fasteners before connecting to the air.
19. DO NOT DEPRESS THE SAFE BRACKET AND THE TRIGGER WHEN LOADING.
20. IF THE FASTENERS ARE JAMMED. Disconnect the tool from the air and remove the
jammed fasteners out.
WARNING: The warning, caution, and instructions explained in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by the operator
that COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO
THIS PRODUCT, BUT MUST BE SUPPLIED BY THE OPERATOR.
To Next Page
Loading...
