6
Specific Safety Rules for Stapler
1. KEEP WORKING AREA CLEAN. Cluttered areas invite injuries.
2. DON’T ALLOW CHILDREN KEEP AT THE WORKING AREA. Don’t let them handle
the tool.
3. DO NOT OPERATE THIS TOOL IF UNDER THE INFLUENCE OF ALCOHOL OR
DRUGS. Read warning label on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not attempt to operate.
4. USE SAFETY GLASSES. Safety glasses should conform to ANSI Z87.1 specifications.
Before operating, wear safety glasses against flying debris from the front and side. Safety
glasses should be worn when loading, operating, unloading or servicing this tool.
5. USE EAR PROTECTION. The working area may be exposed to high noise levels that can
lead to hearing damaged.
6. NEVER USE OXYGEN COMBUSTIBLE GASES, BOTTLED GASES OR HIGH
PRESSURE COMPRESSED GAS AS A POWER SOURCE FOR THIS TOOL. The tool
may explode and cause serious injury.
7. DRESS SAFELY. Protective gloves and nonskid footwear or safety shoes are recommended
when working with and operating this tool. Don’t wear loose clothing or jewelry. They can get
caught in moving parts. Also, wear a protective hair covering to prevent long hair from getting
caught in the tool.
8. DO NOT FIRE TO HARD MATERIALS. Do not attempt to shoot toward hard or brittle
material such as concrete, steel or tile.
9. WHEN OPERATING TOOL. Keep the proper footing and balance to avoid damaged
resulting from losing balance.
10. CHECK DAMAGED PARTS. Before using tool, carefully check if there is any part damaged.
11. REPLACE PARTS AND ACCESSORIES. Only allow use same replacement parts while
servicing. Approved accessories and replacement parts are available.
12. KEEP ALERT. Watch what you are doing. Use common sense. Do not operate any tool when
you are tired.
13. STORE THE TOOL. When not in use, tool should be cleaned, fully assembled and then,
stored in a dry location to reduce rust. For safety, keep out of reach of children.
14. OUTDOORS EXTENSION CORDS. When air compressor is used outdoors, use only
rounded jackets extensions cords intended for outside use. See manufacturer’s manual for the
AWG required for the compressor’s amperage draw.
15. PAY ATTENTION TO AIR HOSE AND THEIR CONNEATIONS. Don’t trip over hoses.
Make sure all connections are tight.
16. AFTER LOADING THE FASTENERS. Never point the tool at yourself or bystanders.
To Next Page
Loading...
Need help?
General
