9
Operation
WARNING - if any parts are missing, do not operate this tool until the missing parts are
replaced. Failure to do so could result in possible serious personal injury.
Lubrication
This tool requires lubrication before using the tool for the first time and before each use. If an
inline oiler is used, manual lubrication through the air inlet is not required.
Note: The work surface can become damaged by excessive lubrication.
Proper lubrication is the owner’s responsibility. Failure to lubrication the
tool properly will dramatically shorten the life of the tool and void your
warranty.
1. Disconnect the air supply from the tool to add lubricant.
2. Turn the tool so the air inlet is facing up. Place 4-5 drops of 30W non-
detergent oil (included) into air inlet.
3. After adding oil, run toll briefly. Wipe off any excess oil from the
exhaust.
Recommended Hookup
Your air tool is fully assembly when you receive it. Before using it, attach the air line and desired
air system accessories. See below for the recommended accessories and connection order. Be sure
the air hose is depressurized when installing or removing adapters to the air line.
NAILER
QUICK
CONNECTOR
OILER
REGULATOR
AIR HOSE
AIR SUPPLYFILTER
To Next Page
Loading...
Need help?
General
