Model Number 6550, 6550T
Motor 120V, 60 Hz, 15A
Cutterhead Speed 8,500 RPM
Cuts Per Minute 17,000
Feed Rate 26 FPM
Max Depth of Cut
3/32 in. (for workpieces under 6 in. wide)
1/32 in. (for workpieces over 6 in. wide)
Table Size 12-1/2 in. x 9-3/8 in.
Extension Table Size 12-1/2 in. x 6-3/4 in.
Base Size 21 in. x 12-1/2 in.
Max Workpiece Width 12-1/2 in.
Min Workpiece Thickness 1/4 in. (1/2 in. recommended minimum)
Max Workpiece Thickness 6 in.
Min Depth Stop Height 5/32 in. (not recommended)
Dust Chute
Outer Diameter - 2-1/20 in. (52.5mm)
Inner Diameter - 1-7/8 in. (47.5mm)
Weight 73 lbs.
SPECIFICATIONS
INTRODUCTION
Thanks for purchasing the WEN Thickness Planer. We know you are excited to put your tool to work, but first, please
take a moment to read through the manual. Safe operation of this tool requires that you read and understand this
operator’s manual and all the labels affixed to the tool. This manual provides information regarding potential safety
concerns, as well as helpful assembly and operating instructions for your tool.
NOTE: The following safety information is not meant to cover all possible conditions and situations that may occur.
WEN reserves the right to change this product and specifications at any time without prior notice.
At WEN, we are continuously improving our products. If you find that your tool does not exactly match this manual,
please visit wenproducts.com for the most up-to-date manual or contact our customer service at 1-800-232-1195.
Keep this manual available to all users during the entire life of the tool and review it frequently to maximize
safety for both yourself and others.
Indicates danger, warning, or caution. The safety symbols and the explanations with them deserve your
careful attention and understanding. Always follow the safety precautions to reduce the risk of fire, electric shock
or personal injury. However, please note that these instructions and warnings are not substitutes for proper ac-
cident prevention measures.
3
To Next Page
Loading...
Need help?
General
