KNOW YOUR DISC SANDER
Carefully remove the tool and all contents from the packaging. Check all components against the diagram below.
If any part is damaged or missing, please contact our customer service at (800) 232-1195, M-F 8-5 CST or email
us at techsupport@wenproducts.com. Do not discard the packaging until the sander is completely assembled.
CLEANING THE SURFACES
1. Your tool comes protected with a layer of anti-rust coating. Clean all rust protected surfaces using a soft cloth,
moistened with kerosene. Do not use gasoline, or cellulose-based solvents such as paint thinner or lacquer thinner,
as these will damage the painted surfaces.
2. Apply a coat of paste wax to the table to prevent rust. Wipe all parts thoroughly with a clean, dry cloth.
1.
2.
3.
4.
Sander (with 60-Grit Sanding Disc attached)
Work Table
Pivot Indexing Pin (x2)
Bevel Locking Handle & Washer (x2)
5.
6.
7.
PACKING LIST
Miter Gauge
Dust Hose
3mm Hex Wrench
Sanding Disc
(60-Grit)
Motor
ON/OFF
Switch with
Safety Key
Spring-loaded
Bevel Locking
Handle
Disc Guard
Work Table
Dust Cover
Miter Gauge
Base
Dust Port
8
To Next Page
Loading...
Need help?
General
