SPINDLE SANDER SAFETY
1. TOOL PURPOSE. This sander is designed to sand
wood or wood-like products only. Sanding or grinding
other materials could result in fire, injury, or damage to
the workpiece. Using the machine for any other purpose
for which it is not designed may result in serious inju-
ries, machine damage and voiding of the warranty.
2. MACHINE MOUNTING. For operation safety, the
sander must be securely mounted onto a flat and stable
surface or stand.
3. PERSONAL SAFETY
• Always wear ANSI Z87.1-approved glasses with side
shields, hearing protection and a dust mask.
• Do not wear loose clothing or jewelry, as they might
get drawn in by the tool. Tie back long hair.
• DO NOT wear gloves while operating this machine.
4. ELECTRIC CORDS. Keep cords away from heat, oil,
sharp edges, and moving parts of the tool. Have an elec-
trician replace or repair damaged or worn cords imme-
diately.
5. TOOL & ACCESSORIES INSPECTION. Before opera-
tion, check the tool and accessories for any damage or
missing parts. Do not use the tool if any part is missing
or damaged. Make sure all adjustments are correct and
all connections are tight. Keep all guards in place.
6. SANDING ACCESSORIES
• Do not use sanding sleeves or drums that are dam-
aged, torn, or loose. Replace worn or damaged
sanding sleeves before operation.
• Always unplug the unit before making adjustments or
changing sandpaper, rubber drums or throat plates.
• Always use the throat plate that matches the diam-
eter of the drum to minimize the gap between the
drum and the throat plate opening; this will reduce
the risk of personal injury.
7. WORKPIECE REQUIREMENTS
• Only stand workpieces sturdy enough to withstand
the force of the sanding spindle.
• Inspect the workpiece for imperfections, nails, sta-
ples, etc. before sanding. Never sand stock that has
questionable imperfections or embedded foreign ob-
jects.
• When sanding a large workpiece, provide additional
support. Do not sand with the workpiece unsup-
ported.
• Sand only one workpiece at a time.
8. PREVENTING ACCIDENTAL STARTING. Make sure
the power switch is in the OFF position prior to plugging
in the machine. Always make sure the power switch is
in the OFF position and the machine is unplugged when
doing any cleaning, assembly, setup operations, or when
not in use.
SPINDLE SANDER SAFETY WARNINGS
WARNING! Do not operate the power tool until you have read and understood the following instructions and
the warning labels.
6
To Next Page
Loading...
Need help?
General
