HEAT GUN SAFETY
1. DO NOT TOUCH the end of the heat gun during or
directly after operation. Let the gun cool down fully
before touching the tip or any nozzles.
2. NEVER use this tool as a hair dryer.
3. DO NOT USE A HEAT GUN near combustible or
flammable materials.
4. TURN HEAT GUN OFF and give it a moment to
cool down before setting it down on any surface.
5. ALWAYS maintain a minimum distance of one
centimeter (1/2 inch) between the nozzle and work
surface. Do not press the gun against any surfaces.
6. UNPLUG the heat gun when not in use.
7. NEVER direct the air flow of the heat gun towards
yourself, anyone else, or any animals.
8. DO NOT LOOK into the hot air nozzle during or
directly after operation.
9. NEVER BLOCK the inlet grill (slits on the side of
the gun) or obstruct the air flow of the unit while the
gun is on.
10. DO NOT STORE the tool away until it has fully
cooled down.
11. DO NOT HOLD a work piece in front of the heat
gun without forceps or clamps, as this will risk put
-
ting your hand in the pathway of the heat flow.
12. DO NOT INSERT anything in the end of the heat
gun.
13. LET THE GUN COOL DOWN before changing ac
-
cessories.
14. ONLY USE THIS HEAT GUN for its intended pur
-
poses.
15. DO NOT DROP or use this tool to hit other ob
-
jects. Do not insert sharp objects into the air inlet
grill or pierce/jab internal parts.
HEAT GUN SAFETY WARNINGS
WARNING! Do not operate the power tool until you have read and understood the following instructions and
the warning labels.
6
To Next Page
Loading...
Need help?
General
