TROUBLESHOOTING GUIDE
WARNING! Stop using the tool immediately if any of the following problems occur. Repairs and replace-
ments should only be performed by an authorized technician. For any questions, please contact our customer
service at 1-(800) 232-1195, M-F 8-5 CST or email us at techsupport@wenproducts.com.
PROBLEM CAUSE SOLUTION
Snipe.
Dull cutting inserts.
Check cutting inserts. Rotate or re-
place as necessary.
Improper support being used.
Support workpiece properly (especially
long workpieces). See recommenda-
tions on p. 6.
Infeed or outfeed table improperly
adjusted.
Adjust infeed and outfeed tables as
described on p. 17.
Table or feed rollers are dirty. Clean table and/or feed rollers.
19
To Next Page
Loading...
