Wenglor P1PY101 - Personnel Qualifications; Modification of Products; General Safety Precautions; Laser;LED Warnings

7
Long-Range Laser Distance Sensors
2.3 Personnel Qualifications
• Suitable technical training is a prerequisite.
• In-house electronics training is required.
• Trained personnel who use the product must have (uninterrupted) access to the operating instruc-
tions.
DANGER!
Risk of personal injury or property damage in case of incorrect initial start-up and
maintenance!
Personal injury and damage to equipment may occur.
• Adequate training and qualification of personnel.
2.4 Modification of Products
DANGER!
Risk of personal injury or property damage if the product is modified!
Personal injury and damage to equipment may occur. Non-observance may result in loss of
the CE mark, and the guarantee may be rendered null and void.
• Modification of the product is impermissible.
2.5 General Safety Precautions
NOTE!
• These instructions are an integral part of the product and must be kept on hand for the
entire duration of its service life.
• In the event of possible changes, the respectively current version of the operating instruc-
tions can be accessed at www.wenglor.com in the product’s separate download area.
• Read the operating instructions carefully before using the product.
• The sensor must be protected against contamination and mechanical influences.
2.6 Laser/LED Warnings
The respective laser class is listed in the product’s technical data.
LASER CLASS 1
EN 60825-1:2014
Laser class 1 (EN 60825-1)
Applicable standards and safety regulations must be observed.
2.7 Approvals and Protection Class
RoHS