5
2 Precaution
Environmental conditions: only use indoor, check the detailed environment conditions for temperature
and humidity in the technical details above.
Do not use the scale in any high temperature fluctuations and avoid strong airflows, vibrations and dust.
The balance could never get wet and make sure that the balance is not used in an environment with
extreme temperature and humidity.
Do not use the balance in explosive conditions.
Only use the extender cable, which with ground wire.
If the power line cable is damaged, the appliance must be unplugged immediately and the power line
cable be replaced.
Place the balance on a stable surface and set it horizontally with the help of the adjustable feet and the
spirit level.
The electronic balance is a precision measuring instrument and must be handled with great care.
Violation of limit of weighing range or impact can cause permanent damage to the balance.
The balance needs a warm up time for about 1 hour before using.
Please do not use aggressive cleaning agents (solvents or similar agents), but a cloth dampened with
mild soap suds. Ensure that no liquid penetrates into the device and wipe with a dry soft cloth.
Do not overload the balance more than 20% of maximum load (Max). Do not press the pan with a hand!
By maintenance please notice the information in Chapter “Maintenance and Servicing”.
If the balance seems not to operate properly, unplug it from the mains and do not use until checked by
authorized service.
All repairs and necessary regulations can be made by authorized personnel only.
Carefully read this operation manual before setup and commissioning.
3 Transportation and Storage
3.1 Acceptance check
When receiving the appliance, please check packaging immediately, and the appliance itself when
unpacking for possible visible damage.
3.2 Packing
Keep all parts of the original packaging for transportation
Disconnect all cables and remove loose parts before dispatch
4 Unpacking, Setup and Commissioning
4.1 Installation Site, Location of Use
The balances are designed in a way that reliable weighing results are achieved in common conditions of use.
You will work accurately and fast, if you select the right location for your balance.
Therefore, observe the following for the installation site:
To Next Page
Loading...