WERTHEIM 7000 - Maintenance Procedures; Emptying the Cleaner; Cleaning Filters; Replacing the HEPA Filter

11
EMPTYING YOUR CLEANER
Before emptying, switch ‘OFF’ and unplug the appliance
• An indicator light will illuminate when the dust bag is full
• Pull upwards on the lid release button and lift up the dust bag lid
• Slide out dust bag and replace, then close the lid
CLEANING YOUR FILTERS
• Pull upwards on the lid release button and lift up the dust bag lid
• Slide out dust bag
• Firmly pull the fi lter cover tab to release and remove
• Separate fi lter from fi lter cover and rinse with warm water
Ensure fi lter is completely dry before re-fi tting
REPLACING THE HEPA FILTER
Before replacing fi lters, switch ‘OFF’ and unplug the appliance
• Pull upwards on the lid release button and lift up the dust bag lid
• Unclip and slide out the HEPA fi lter
• Replace the HEPA fi lter and close the dust bag lid
CLEARING POWERHEAD OBSTRUCTIONS - RESETTING POWERHEAD
If the powerhead brushbar is obstructed, it may automatically shut off. If this happens
you will need to clear any obstructing objects and reset the powerhead
• Switch ‘OFF’ and unplug the appliance
• Clear and remove all obstructions caught within the powerhead brushbar
• Press the red button on rear of powerhead to reset
• Return plug into power socket and switch both the appliance and powerhead ‘ON’
to resume cleaning