What to do if the charging indicator light failed to turn on during charging of my WERTHEIM Evolution Vacuum Cleaner?
If the charging indicator light on your WERTHEIM Vacuum Cleaner doesn't turn on during charging, ensure the cleaner is properly connected to the charger adapter. Also, verify that you are using the correct charger model, which should be ZD12D260050AU.
Why is the charging indicator flashing red during operation of my WERTHEIM Evolution Vacuum Cleaner?
If the charging indicator flashes red during operation of your WERTHEIM Vacuum Cleaner, it could be due to a jammed roller brush or a blocked suction inlet. To resolve this, turn off the cleaner and remove the battery. Then, clean the roller brush or clear the suction inlet following the maintenance procedures.
Why does my WERTHEIM Evolution have reduced suction?
If your WERTHEIM Vacuum Cleaner experiences reduced suction, there might be a few reasons. First, the dust canister could be full, in which case you should empty it. Secondly, the dust bin filter may be blocked, so try cleaning or replacing it. Finally, the airway might be obstructed; make sure to clear it for optimal performance.
How to fix WERTHEIM Vacuum Cleaner that doesn’t start?
If your WERTHEIM Vacuum Cleaner doesn’t start, the most likely cause is a flat battery. To fix this, charge the vacuum cleaner.
Why WERTHEIM Vacuum Cleaner has insufficient application time after charging?
If your WERTHEIM Vacuum Cleaner isn't running for long enough after charging, it could be due to insufficient charging time. Ensure you fully charge the battery as described in the charging section. Alternatively, the battery may have a normal discharge reduction, suggesting it's time to purchase a new battery.
General| Brand | WERTHEIM |
|---|---|
| Model | Evolution |
| Category | Vacuum Cleaner |
| Language | English |
Technical details of the Wertheim Evolution Handstick.
Essential safety guidelines to follow during operation and handling.
Comprehensive safety instructions for using the appliance.
Instructions for assembling the charging stand base and dock.
To Next Page
