Carpet Shampooer SE2000
9
MAINTENANCE
WARNING: Always unplug power cord from electrical outlet
before performing any maintenance task on the carpet
shampooer.
Emptying the Water Tanks
IMPORTANT: Do not wash lters in the washing machine, hand wash only.
Only air dry the lters and do not in use a hair dryer.
Note: Cleaning solution may leak out of the shampooer once it is
deactivated. For this reason, have a cloth laid out that you can place the
shampooer on after use.
1. Pull up the dirty water tank handle and remove the tank from the base of
the appliance.
2. The cap is on the back of the tank. Turn it 90° counterclockwise to open it.
3. Pour out the dirty water and rinse the tank out thoroughly with warm water
(max. 38°C).
4. The exhaust air lter is located at the top of the dirty water tank. Press the
locking mechanism outward toward the lter and remove the lter mount.
5. Take the lter out of the holder and rinse it off with warm water.
6. Take the protective motor lter out of the main unit and rinse it off
withwarm water.
7. Pour the leftover cleaning solution out of the fresh water tank and clean
the tank thoroughly with warm water.
8. As required, wipe down the appliance with a moist cloth.
9. Let all parts of the appliance (even the brushes on the bottom of the
shampooer, dry completely before storing it.
Replace the belt / the roller brush
WARNING: Always unplug power cord from electrical outlet before
performing any service on extractor.
Due to the normal wear and tear, the belt may break and the roller brush will
To Next Page
Loading...
