22
EN
button for about 2 seconds then
the device will enter into continuous
measurement mode, right now the main
measuring area will show the measured
result data in real time, the supplementary
displaying area will show the max and min
measured values during the measuring
process this time. In the continuous
measurement mode, to shortly press
the
or button, it will quit the
continuous measurement mode.
3. Area Measurement
To shortly press button, the will
be appeared on the screen, showing that
it entered into area measurement
mode, and please perform following
operations according to instruction:
Currently the longer edge of this
rectangular sign will flash, while the
measuring point is locked, to press
button for the measurement on the longer
edge of the rectangular, now the shorter
edge of the rectangular will flash and
the measuring point need to be locked
once again, to press the button for
measurement on shorter edge of the
rectangular.
The device will calculate the area
automatically, and calculated result will
be shown in the main displaying area, the
measured results of both the longer and
shorter edges of the rectangular will be
shown in the supplementary displaying
area.
To press the
button, clear off the last
measured result, and arrange the new
measurement.
To press the
button to quit the area
measurement mode.
4. Volume Measurement
To shortly press the button, will
be appeared on the screen, showing that it
entered into volume measurement mode,
please perform following operations
according to the instruction:
Now the longer edge of this cuboid will
flash, after the measuring point is locked,
to press button for measurement
on the length edge of the rectangular,
and then the width edge of the cuboid
will flash, the measuring point need to be
locked again, and press the button
for measurement on the width edge of the
cuboid. And now the cuboid sign will flash,
to lock the measuring point once again, to
press the button for measurement on
the height edge of the cuboid.
The device will calculate the volume
automatically, and the calculated result
will be shown in the main displaying
area, the measured length, width and
height of the cuboid will be shown in the
supplementary displaying area.
To press the
button to clear off the
last measured result and arrange the new
measurement.
To press the button to quit the volume
measurement mode.
To Next Page
Loading...