STEP
-
BY
-
STEP CONSOLE OPERATION
Step onto the foot pads on the treadmill. Find the clip
attached to the key (see the drawing above), and slide
the clip onto the waistband of your clothes. Next, insert
the key into the console. Test the clip by carefully
taking a few steps backward until the key is pulled
from the console. If the key is not pulled from the
console, adjust the position of the clip as needed.
Then, remove the key from the console.
Follow the steps below and on page 10 to operate the
console.
Insert the key fully into the console.
Inserting the key will
not turn on the dis-
play. The display will
turn on when the
ON/RESET button is
pressed or when the
walking belt starts.
Note: If you just in-
stalled batteries, the display will already be on.
1
DIAGRAM OF THE CONSOLE
Clip
Key
Speed Control
Water Bottle
Holder
(Bottle is not
included)
Monitor Display
CAUTION: Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing above)
while operating the treadmill. When the key
is removed from the console, the walking
belt will stop.
•
Adjust the speed in small increments.
•
To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable water
bottle.
9
To Next Page
Loading...
Need help?
General