Weslo Inversion Flex WLBE0109.0 - Page 10

10
9. Attach the Right Handlebar (21) to the M8 x
30mm Bolts (45) on the Front and Rear Frames
(5, 6) with two M8 Nuts (40). Make sure that
t
he Right Handlebar is oriented as shown.
R
epeat this step with the Left Handlebar (9).
11. Make sure that all parts are properly tightened before you use the inversion table.
10. Press the Right Cover (12) onto the right
Saddle Plate (20).
Attach the Right Cover (12) to the Right
Handlebar (21) with a Wingnut (46).
Repeat this step with the Left Cover (11).
9
21
45
45
6
5
40
9
10
12
11
20
21
46