English - 12
BREAD PAN PROBLEMS
Knead blade cannot be removed
•
Add warm water to the bread pan and allow the knead blade to soak before trying
to remove. Follow the cleaning instructions. You may need to twist the knead
blade slightly after soaking to loosen. Do not immerse the bread pan in water.
Bread sticks to bread pan/difficult to shake out
•
Can happen over prolonged use – Wipe the inside of the bread pan, from the ribs
down with vegetable oil or solid shortening. Or add 1 tsp. vegetable oil to the liquid
in the bread pan before adding dry ingredients. Do not use vegetable spray as
sticking can worsen. Or, let bread sit in bread pan for 10 minutes before shaking
out. Replacement bread pan may be ordered. See Warranty section.
MACHINE MECHANICS
Ingredients not mixed
•
Did not start machine – After programming the control panel, press the
“START/STOP” button to turn on.
•
Forgot to put knead blade in bread pan – Always make sure the knead blade is on
the shaft in the bottom of the bread pan before adding ingredients.
Burning odor noted during operation
•
Ingredients spilled inside oven – Be careful not to spill ingredients when adding to
the bread pan as they will burn on the heating unit and cause smoke.
•
Bread pan leaks – Replacement bread pan may be ordered. See Warranty
section.
•
Exceeding capacity of bread pan – Do not use more ingredients than
recommended in recipe and always measure accurately.
Machine unplugged by mistake or power lost during use for longer than 5
minutes. How can I save the bread?
•
If machine is in knead cycle, reprogram to the same bread setting and turn the
machine back on.
•
If machine is in rise or bake cycle, preheat conventional oven to 350°F (177°C).
Carefully remove the bread pan from the machine and bake on rack in center of
oven for 20-25 minutes or until golden brown.
Alert sounds, display shows “H H H” and machine cannot be turned on.
•
Breadmaker too hot to make consecutive loaves – Unplug the cord from the outlet
and allow to cool with the bread pan removed and cover open for 15-20 minutes.
Plug the cord back in the outlet, add bread pan and start machine. If you are
making consecutive loaves of bread, this error message is not uncommon and
does not indicate defect in the bread maker.
Alert sounds, display shows “E E E” and machine cannot be turned on.
•
Breadmaker is malfunctioning – See Warranty section for service information.
To Next Page
Loading...
Need help?
General
