7
Machine must not be operated at any new site, or
at the start of a new shift, until a visual inspection
is made of the condition of the equipment.
The operator must report and damage, defects,
problems, or accidents to his/her work supervisor
and next shift operator.
Safety Regulations
All personnel operating, transporting, assembling,
or maintaining a Warrior Shotcrete Pump should
understand and comply with the following safety
regulations:
Anyone near the unit must wear appropriate
clothing (NO loose clothing, neck ties, rings,
open-toed shoes) and protective equipment
(e.g. hard hat, safety goggles, hearing protection,
and close-toed shoes) required by Federal,
States, local, and job site regulations. [[Hearing
protection OSHA requirements are listed in "29
CFR Ch. XVII Section 1910.95 Occupatoinal Noise
Exposure," which can be found at www.osha.gov]]
Do not operate a malfunctioning unit or if it has
not been leveled and stabilized.
Before use, check machine's operating condition.
Never open hopper grate cover while operating
pump. Though Warrior Shotcrete Pumps are
equipped with a trigger sensor to shut off
machine when grate is opened, it may not work,
and the operator is in danger off contacting
moving parts in hopper.
Never enter the hopper grate with any part of
your body while the machine is on.
Do not stand on hopper grate.
If the hopper needs repairs, ensure the machine
is OFF and the accumulator pressure reads
ZERO. The system uses a hydraulic accumulator
which contains a stored charge of high pressure
oil to shift the S-tube. Stop engine, turn ignition
key to OFF, and wait 10-15 seconds until the
accumulator pressure gauge reads zero.
Make sure decals and operations instructions are
legible.
To Next Page
Loading...