9
Pressure Test Switch (12)
Must be up in the Pump position for normal operation.
In the Pressure Test position, the pump will make one
reverse stroke, stop, then the main hydraulic system
will go to maximum pressure.
On/Off/Remote Switch (13)
Turns the pump on and off at the Control Panel. When
in the Remote position, the pump can be turned on
and off with a Remote Control Cable.
Diagnostics Connection (14)
Plug used for troubleshooting machine errors.
Ignition Switch (15)
Two positions: OFF and ON. On allows the engine to
start. Off shuts off the fuel to the engine.
Engine Speed (16)
Sets the engine speed. Push the level up for more RPM
or down for less RPM to set the engine speed.
Flow Control (17)
Sets the hydraulic pump output and thus the concrete
pumping output. Push the lever up for more flow and
down for less flow or volume.
Pumping Pressure (18)
Gauge indicates hydraulic system pressure in psi.
Note: this is hydraulic fluid pressure not actual pump
outlet pressure.
Swingtube Pressure (19)
Gauge indicates stored hydraulic pressure within the
swingtube in psi.
To Next Page
Loading...