Westinghouse WGEN5300DFC User Manual (English)

Questions and Answers:

S
Sherry WhiteAug 2, 2025
Why does my Westinghouse Portable Generator start then shut off?
- K
  Kimberly FloresAug 3, 2025
  If your Westinghouse Portable Generator starts and then shuts down, there are a few potential causes. Make sure that you have enough fuel by refueling the generator. Check the engine oil level and correct it if it's incorrect. A dirty air filter can cause the engine to shut down, so clean it. Contaminated fuel may also be the problem, so drain the fuel tank and refuel with fresh gasoline.
C
Claudia WoodsAug 7, 2025
What to do if my Westinghouse WGEN5300DFC has no power at AC receptacles?
- J
  Jack GutierrezAug 7, 2025
  If your Westinghouse Portable Generator is not providing power at the AC receptacles, the AC circuit breakers may have tripped. Check the AC loads and reset the circuit breakers. Also, the issue may be with the power tool or appliance you are using; replace or repair the faulty tool or appliance, then stop and restart the engine.
T
tmarshAug 11, 2025
Why does my Westinghouse WGEN5300DFC engine lack power?
- C
  Crystal ClaytonAug 11, 2025
  If your Westinghouse Portable Generator engine lacks power, the air filter may be restricted. Clean or replace the air filter. Also, bad fuel can cause a lack of power; drain the fuel tank and refuel with fresh gasoline.
A
Ann MilesAug 16, 2025
What to do if my Westinghouse WGEN5300DFC runs rough when load applied?
- J
  Jason WatersAug 16, 2025
  If the engine of your Westinghouse Portable Generator runs rough or bogs when a load is applied, the air filter may be dirty. Clean the air filter. The generator might also be overloaded, so unplug some devices. A faulty power tool or appliance can also cause this issue; replace or repair the tool or appliance, then stop and restart the engine.
A
alexis64Aug 19, 2025
Why do I smell propane fuel from my Westinghouse Portable Generator?
- B
  Brittney LaneAug 19, 2025
  If you notice a propane fuel smell with your Westinghouse Portable Generator, it could be that the fuel regulator, fuel hose, or fittings are not securely sealed. Use a soap solution to check each connection and tighten as needed. The propane fuel regulator is equipped with a vent that will allow a small amount of propane fuel vapor to escape from the regulator when the propane tank valve is opened. This can be normal providing the venting of the propane is brief. It also may be caused by residual fuel from the carburetor dispersing after operation, which is normal and needs no correction.
C
Christopher WilliamsAug 25, 2025
Why is there frost on the propane tank of my Westinghouse Portable Generator?
- W
  williecallahanAug 25, 2025
  If you see frost on the propane tank or regulator of your Westinghouse Portable Generator, it may be because the temperature of the propane tank has dropped below the dew point, causing condensation to turn to frost or ice, typically in humid conditions. If all propane fuel handling equipment is functioning normally, no correction is needed. If you suspect your propane fuel tank is not equipped with an Overfilling Prevention Device (OPD), discontinue operation immediately and replace the propane fuel tank with a propane tank equipped with a an OPD. If you suspect your propane fuel tank has been overfilled, discontinue operation immediately and return the propane fuel tank to the place of purchase or refilling.
M
Michael MartinAug 28, 2025
What to do if my Westinghouse Portable Generator has poor performance on propane?
- N
  Nicholas LewisAug 28, 2025
  If your Westinghouse Portable Generator experiences poor performance or engine stalling on propane, inspect the propane fuel line for kinks or obstructions and remove them. Ensure the fuel selector valve is properly positioned, rotating it fully until the pointer aligns with the desired fuel. If gasoline wasn't purged from the carburetor before switching to propane, close the propane fuel tank valve, move the fuel selector switch to gas, start the engine, and let it run until the gasoline is consumed; then, begin the propane startup procedure.

Westinghouse WGEN5300DFC Specifications

General

Brand	Westinghouse
Model	WGEN5300DFC
Category	Portable Generator
Language	English

Summary

Introduction and Specifications

Detailed Generator Specifications

Detailed technical specifications for the generator.

Generator Operating Conditions Notice

Important generator operating conditions and limitations.

Generator Product Registration

Instructions for generator warranty registration.

Generator Safety

Safety Terminology Definitions

Definitions of safety terms: DANGER, WARNING, CAUTION, NOTICE.

Generator Safety Symbols and Alerts

Identification and meaning of safety symbols.

Safety Instructions and Warnings

Generator Safety Usage Instructions

Guidance on correct/incorrect usage to prevent generator hazards.

CO Detector Recommendation

Recommendation for installing CO detectors.

Fire and Electrical Hazard Warnings

Warnings about electrical hazards and wet conditions.

General Safety & Fuel Handling

General Generator Safety Rules

Essential safety rules for generator operation.

Safe Fuel Handling and Storage

Safe handling and storage of gasoline and propane.

LPG/Propane Safety

LPG/Propane Hazard and Handling

LPG/propane fire, explosion, and handling warnings.

Propane Tank Connection and Storage

Propane tank connection, operation, and storage guidelines.

Generator Safety Label Identification

Hazardous Labels on Generator

Explanation of generator danger and hazard labels.

Operation and Cautionary Labels

Labels for starting, fueling, and emissions.

Safety Labels Continued

Generator Model and Info Labels

Labels showing model, serial number, and certifications.

Maintenance and Service Contact Labels

Air filter maintenance and service contact info.

CO Sensor and Control Panel Functions

CO Sensor Operation and Auto-Shutoff

CO sensor detection and reaction to carbon monoxide.

CO Sensor Indicator Light Meanings

Meaning of CO sensor red and yellow indicator lights.

CO Sensor Action Label Instructions

Steps for CO sensor-triggered shutoff.

Generator Control Panel Components

Control Panel Component Identification

Identification and description of control panel components.

CO Sensor Lights on Control Panel

Control panel CO sensor indicator lights.

Battery Power Indicator Light

Indicates generator battery power status.

Generator Component Identification

Key Engine Component Labels

Labels for key engine assembly parts.

Key External Generator Labels

Labels for external generator components.

Assembly: What's Included & Initial Oil

Generator Package Contents

List of items included in the generator package.

First-Time Engine Oil Fill

Procedure for adding engine oil before first use.

Generator Fueling Procedures

Gasoline Fuel Tank Filling

Safe instructions for filling the gasoline fuel tank.

Gasoline Fuel Type and Usage

Specifications for gasoline type and ethanol content.

Fuel Stabilizer Application

Guidance on using fuel stabilizer for storage.

Connecting Propane Tank and Battery

LPG/Propane Tank Connection Guide

Instructions for connecting an LPG/propane tank.

Battery Connection Procedure

Procedure for connecting the generator battery.

Operation: Location, Grounding, Voltage

Generator Placement and Ventilation

Generator placement and ventilation safety requirements.

Generator Electrical Grounding

Generator electrical safety grounding information.

Voltage Selector Switch Usage

Explanation of voltage selector switch usage.

Operation: Altitude, Fuel Select, Break-in

High Altitude Generator Adjustments

Altitude effects on generator performance and kits.

Fuel Selector Switch Usage

Procedure for switching between gasoline and propane.

Generator Engine Break-in Period

Recommended procedure for the initial engine break-in.

Starting Engine with Gasoline

Step-by-step guide to starting the gasoline engine.

Operation: Propane Start, Switching, Stopping

Starting Engine with Propane

Step-by-step guide to starting the propane engine.

Switching Between Fuel Sources

Procedures for switching between fuel sources.

Generator Engine Shutdown

Safe generator engine shutdown procedures.

Generator Capacity & Power Management

Understanding Generator Capacity Limits

Determining and avoiding generator wattage overload.

Sequential Power Load Management

Sequential method for adding electrical loads.

Proper Extension Cord Sizing

Guidelines for selecting appropriate extension cords.

Extension Cords and Transporting the Generator

Extension Cord Safety Considerations and Sizing

Extension cord safety considerations and sizing.

Safe Generator Transporting

Safe instructions for moving and transporting the generator.

Maintenance Schedule and Reminders

Recommended Generator Maintenance Schedule

Recommended generator maintenance intervals.

Generator Maintenance Reminder Codes

Explanation of displayed maintenance reminder codes.

Generator Replacement Parts

List of common generator replacement part numbers.

Air Filter & Engine Oil Maintenance

Air Filter Cleaning and Replacement

Steps for cleaning and replacing the air filter.

Checking Engine Oil Level

How to check and maintain engine oil level.

Engine Oil Change Procedure

Steps for draining and refilling engine oil.

Spark Plug & Fuel Filter Maintenance

Spark Plug Inspection and Replacement

Spark plug inspection, cleaning, and gapping.

Fuel Filter Replacement Procedure

Instructions for replacing the fuel filter.

Fuel Valve, Spark Arrestor & Storage

Fuel Valve Maintenance

Fuel valve and filter servicing procedures.

Spark Arrestor Cleaning and Service

Spark arrestor cleaning and inspection.

Generator Storage Best Practices

Recommended generator storage procedures.

Fuel Draining & Valve Clearance

Carburetor Float Bowl Draining

Steps to drain carburetor float bowl for storage.

Fuel Tank Draining for Storage

Procedure for draining the entire fuel tank.

Engine Valve Clearance Adjustment

How to check and adjust engine valve clearance.

Troubleshooting Engine Issues

Engine Won't Start Troubleshooting

Common causes and solutions when the engine won't start.

Engine Starts Then Shuts Down

Troubleshooting for engines that stop shortly after starting.

Engine Power Loss Troubleshooting

Diagnosing and fixing issues with reduced engine power.

Troubleshooting Propane Operation

Propane Leak Detection and Fixes

Addresses causes and corrections for propane leaks.

Propane Performance and Stalling

Solutions for performance issues when running on propane.

Engine Exploded View Diagram

Generator Exploded View Diagram

Generator Electrical Schematics

Related product manuals

Westinghouse WGen5300DF

38 pages

Westinghouse WGen5300

92 pages

Westinghouse WGen5300s

34 pages

Westinghouse WGen5300v

77 pages

Westinghouse WGen5500

44 pages

Westinghouse WGen6000

36 pages

Westinghouse WGen7500

44 pages

Westinghouse WGen9500

29 pages

Westinghouse WGen3600

36 pages

Westinghouse WGen9500DF

35 pages

Westinghouse WGen3600DF

36 pages

Westinghouse WGen11500TFc

108 pages

Westinghouse WGEN5300DFC User Manual

Table of Contents

Questions and Answers:

Westinghouse WGEN5300DFC Specifications

Summary

Introduction and Specifications

Detailed Generator Specifications

Generator Operating Conditions Notice

Generator Product Registration

Generator Safety

Safety Terminology Definitions

Generator Safety Symbols and Alerts

Safety Instructions and Warnings

Generator Safety Usage Instructions

CO Detector Recommendation

Fire and Electrical Hazard Warnings

General Safety & Fuel Handling

General Generator Safety Rules

Safe Fuel Handling and Storage

LPG/Propane Safety

LPG/Propane Hazard and Handling

Propane Tank Connection and Storage

Generator Safety Label Identification

Hazardous Labels on Generator

Operation and Cautionary Labels

Safety Labels Continued

Generator Model and Info Labels

Maintenance and Service Contact Labels

CO Sensor and Control Panel Functions

CO Sensor Operation and Auto-Shutoff

CO Sensor Indicator Light Meanings

CO Sensor Action Label Instructions

Generator Control Panel Components

Control Panel Component Identification

CO Sensor Lights on Control Panel

Battery Power Indicator Light

Generator Component Identification

Key Engine Component Labels

Key External Generator Labels

Assembly: What's Included & Initial Oil

Generator Package Contents

First-Time Engine Oil Fill

Generator Fueling Procedures

Gasoline Fuel Tank Filling

Gasoline Fuel Type and Usage

Fuel Stabilizer Application

Connecting Propane Tank and Battery

LPG/Propane Tank Connection Guide

Battery Connection Procedure

Operation: Location, Grounding, Voltage

Generator Placement and Ventilation

Generator Electrical Grounding

Voltage Selector Switch Usage

Operation: Altitude, Fuel Select, Break-in

High Altitude Generator Adjustments

Fuel Selector Switch Usage

Generator Engine Break-in Period

Starting Engine with Gasoline

Operation: Propane Start, Switching, Stopping

Starting Engine with Propane

Switching Between Fuel Sources

Generator Engine Shutdown

Generator Capacity & Power Management

Understanding Generator Capacity Limits

Sequential Power Load Management

Proper Extension Cord Sizing

Extension Cords and Transporting the Generator

Extension Cord Safety Considerations and Sizing

Safe Generator Transporting

Maintenance Schedule and Reminders

Recommended Generator Maintenance Schedule

Generator Maintenance Reminder Codes

Generator Replacement Parts

Air Filter & Engine Oil Maintenance

Air Filter Cleaning and Replacement

Checking Engine Oil Level

Engine Oil Change Procedure

Spark Plug & Fuel Filter Maintenance

Spark Plug Inspection and Replacement

Fuel Filter Replacement Procedure