Westinghouse WGen5300s User Manual (English)

Questions and Answers:

C
Christine LoveJul 27, 2025
How to fix a Westinghouse WGen5300s Portable Generator that will not start?
- A
  Angela BrownJul 27, 2025
  If your Westinghouse Portable Generator won't start or remain running, consider these potential causes: * Ensure the fuel shutoff valve is in the ON position. * Check if the generator is out of gasoline and add gasoline if needed. * Inspect and clean fuel delivery passages to ensure fuel flow is not obstructed. * For electric start models, check the battery output and charge the battery if necessary. * Inspect and clean the air filter if it's dirty. * Check the oil level and add oil if necessary. * Ensure the spark plug boot is fully engaged with the spark plug tip by firmly pushing down on it. * Remove and check the spark plug, replacing it if faulty. * Check and clean the spark arrestor if it's dirty or plugged. * Drain stale fuel and replace it with fresh fuel.
R
Rebecca WarrenAug 1, 2025
Why does my Westinghouse WGen5300s engine runs erratic?
- B
  Bobby RobertsAug 1, 2025
  An erratic engine in your Westinghouse Portable Generator can be caused by a dirty air filter, so you should clean it. Also, changes in engine speed may occur as applied loads cycle on and off; this is a normal condition.
Y
yramirezAug 5, 2025
Why does my Westinghouse Portable Generator lack power?
- K
  Kelly WrightAug 5, 2025
  Your Westinghouse Portable Generator engine may lack power due to: * A restricted air filter. Clean or replace it. * Bad fuel. Drain the fuel tank and refuel with fresh gasoline.
O
osandersAug 9, 2025
What to do if my Westinghouse WGen5300s starts, then shuts down?
- M
  Mrs. Katie Mercado MDAug 9, 2025
  Your Westinghouse Portable Generator might start and then shut down for these reasons: * You're out of fuel. Refuel the generator. * The engine oil level is incorrect. Check and correct the engine oil level. * The air filter is dirty. Clean the air filter. * The fuel is contaminated. Drain the fuel tank and refuel with fresh gasoline.
T
Taylor ValenciaAug 13, 2025
Why does my Westinghouse Portable Generator run rough when load applied?
- S
  Sheri DawsonAug 13, 2025
  Your Westinghouse Portable Generator engine may run rough or bog down when a load is applied due to: * A dirty air filter. Clean the air filter. * The generator being overloaded. Unplug some devices. * A faulty power tool or appliance. Replace or repair the tool or appliance, then stop and restart the engine.
E
Evan KingAug 18, 2025
What to do if my Westinghouse WGen5300s suddenly stops running?
- J
  Jose WarrenAug 18, 2025
  If your Westinghouse Portable Generator suddenly stops, there are a few things you can check: * First, check the fuel level and add fuel if necessary. * Second, verify the oil level, adding oil if needed, as the low oil shut down switch may have stopped the engine. * Finally, the generator may have too much load, in this case, restart the generator and reduce the load.
J
Jeffrey ThomasAug 22, 2025
What to do if there is no power at AC receptacles of my Westinghouse WGen5300s Portable Generator?
- R
  Rebecca BairdAug 22, 2025
  No power at the AC receptacles of your Westinghouse Portable Generator may be caused by: * Tripped AC circuit breaker(s). Check the AC loads and reset the circuit breaker(s). * A faulty power tool or appliance. Replace or repair the tool or appliance, then stop and restart the engine.

Westinghouse WGen5300s Specifications

General

Type	Portable Generator
Rated Wattage	5300 Watts
Starting Wattage	6600 Watts
Fuel Type	Gasoline
Engine Type	4-Stroke OHV
Engine Displacement	274 cc
Run Time at 25% Load	18 hours
Voltage	120/240 V
Frequency	60 Hz
Noise Level	68 dBA
Wheel Kit	Yes
Run Time at 50% Load	14 h
Starting System	Recoil Start
Outlets	(2) 120V 20A GFCI Outlets, (1) 120/240V 30A Outlet