What to do if program monitor light is on and start/pause light is flashing on Westinghouse WSF6608 Dishwasher?
If one of the program monitor lights is on and the start/pause light is flashing on your Westinghouse Dishwasher, it might be because the door isn't fully closed. Make sure to shut the door properly.
Why won’t my Westinghouse Dishwasher program start?
If your Westinghouse Dishwasher program won’t start, try these checks: * Ensure the plug is correctly connected. * Check your indoor fuses. * Confirm that the water inlet tap is turned on. * Ensure the machine door is completely closed. * Verify the machine isn't switched off at the Power On/Off button. * Check that the water inlet filter and the machine filters aren't clogged. * If it's the first time you're using it, check if the drain spigot’s membrane has been removed or if the spigot is blocked. * See if the delay start function has been selected and reset it if necessary.
Why are there partial food wastes left on the dishes in my Westinghouse WSF6608?
Partial food wastes left on the dishes in your Westinghouse Dishwasher may be because dishes were placed incorrectly, the basket was overloaded, dishes were leaning against one another, there was a very small amount of detergent added, an unsuitable wash program was selected, the spray arm was clogged with food wastes, filters were clogged or incorrectly fitted, or the water drain pump was clogged.
Why does my Westinghouse Dishwasher stop mid-cycle?
If your Westinghouse Dishwasher stops during a wash operation, it could be due to a power failure, water inlet failure, or the program might be on standby mode.
Why won’t the dishes dry in my Westinghouse WSF6608 Dishwasher?
If the dishes in your Westinghouse Dishwasher won’t dry up, it could be because a program without a dry operation was selected, the rinse aid dosage is set too low, or the dishes were unloaded too fast.
Why are there whitish stains on dishes from my Westinghouse WSF6608?
Whitish stains on dishes from your Westinghouse Dishwasher may appear if a very small amount of detergent is being used or the rinse aid dosage setting is at a very low level.
Why are there detergent residues in the detergent compartment of my Westinghouse WSF6608 Dishwasher?
Detergent residues are left in the detergent compartment of your Westinghouse Dishwasher if detergent has been added when the detergent compartment was wet, or a large dish in the lower basket has blocked the dispenser door.
Why are there rust stains on the dishes from my Westinghouse WSF6608?
Rust stains on the dishes from your Westinghouse Dishwasher may be caused by insufficient stainless-steel quality of the dishes washed or unhealthy mains grounding.
Explanation of buttons, indicators, and basic functions.
Concise steps for starting, changing, and cancelling programs.
Ensuring safe and correct electrical hook-up for the appliance.
First-time use checks, detergent types, and compartment filling.
How to correctly fill and adjust the rinse aid level.
Overview of programs, temperatures, water, and energy usage.
Steps to power on the unit and select a wash program.
How to cancel a running program and safely turn off the machine.
Instructions for cleaning the interior, door seals, and filters.
General| Type | Built-In |
|---|---|
| Energy Star Qualified | Yes |
| Number of Wash Cycles | 6 |
| Control Type | Electronic |
| Color | Stainless Steel |
| Soil Sensor | Yes |
| Delay Start | Yes |
| Third Rack | No |
| Stainless Steel Interior | Yes |
| Heated Dry | Yes |
| Noise Level | 52 dB |
To Next Page