c. Awning / Slide Controls:
Switch illumination, as shown, will indicate
retract button is pressed.
SELECT button: cycles through the selections (highlighting constant blue one at a
time).
Extend Button: press & hold to extend the selected item (Awning 1, 2, Slide 1,2,3),
and the selected item shall be turned on and extending. Release the button, the
output of the selected item shall be turned off.
Retract Button: press & hold to retract the selected item, and the selected item
shall be turned on and retracting. Release the button, the output of the selected
item shall be turned off.
3. Setup Mode (For OEM installation)
a. Enter/ Exit Setup Mode
Enter Setup Mode: Press & Hold SELECT button > 7 seconds.
Exit Setup Mode: To SAVE CHANGES, Press & Hold SELECT button > 7 seconds or
to EXIT WITHOUT SAVING, wait for Screen Timeout > 60 seconds.
b. Enabling/Disabling Devices in Setup Mode
SETUP MODE:
SELECT, EXTEND, RETRACT buttons changes to WHITE color.
SETUP MODE Text is illuminated WHITE. (ON [or] OFF) text is illuminated WHITE
(indicates the status of the selected item).
The selected item will be BLUE. SELECT button cycles through the selections
highlighting BLUE one at a time: AWNING 1/ AWNING 2/ SLIDE 1/ SLIDE 2/ SLIDE
3/ GRAY2 /GRAY3 /BLACK2/ LIGHT 1/ LIGHT 2/ LIGHT 3/ LIGHT 4/ WATER PUMP/
WATER HEATER-ELECTRIC/ WATER HEATER-GAS/ OTA
For the selected item:
The EXTEND button is actuated to ENABLE (ON) the selected item. The RETRACT
button is actuated to DISABLE (OFF) the selected item.
To Next Page
Loading...