Notes:
• Make sure all the connections are tight. Loose connections can overheat and result in a
potential hazard.
• The installation of a fuse must be on the positive cable. Failure to place a fuse on this cable
running between the inverter and battery creates a safety hazard.
• Do not place anything between the battery cable lug and the terminal surface. If desired, a
at washer can be used on top of the terminal to protect it as the nut is tightened.
• During the rst installation, a small spark is a normal phenomenon when the battery is
connected because the internal capacitors will charge.
18
To Next Page
Loading...
