Wfly WFT06II - Idle Throttle Curve; Swash Plate Settings

To Next Page

To Previous Page

10- I TH (Idle throttle curve)

11- SWAH (Swash)

●Function description

NTH Normal Throttle curve and ITH idle throttle curve are for different situation. NTH is for normal situation,

ITH is for IDLE situation. Switch K4 on the upper situation is for IDLE on the lower position is for Normal

situation.

●Setting method

1, select ITH 10 under setting mode

2 press UP/DOWN to select position, press +/- to change value

3, Press and hold Menu to exit or press menu to switch to next item

●Function description

Swash function is to adjust AIL, ELE PIT when selecting swash.

●Setting method: refer to basic process. When parameter is 1, normal mode, no swash supported. Swash

mode is activated when Parameter is 3. Use +/- button to change value.

1, select SWAH 11 under setting mode

2, press UP/down to select position, press +/- change value

3, Press and hold Menu to exit or press menu to switch to next item

Helicopter

L H

3/ 41/ 4

00.0%

25.0%

50.0%

75.0%

100. 0%