10- FLER (Flap aileron mix control)
11-FTRM Flaperon trim
●Function description
This function is to for aileron to act like flaperon even using two servos on aileron. Due to flaperon, aileron
can move up or down accordingly. Aileron differential can also be achieved.
AIL 1 ↓ aileron 1 down; Ail1 aileron 1 up; Ail2 aileron 2 down; AIL2 aileron2 UP; FLP1 Flap 1; FLP2 FLAP
2.
●Setting method
1, select FLER 10 under setting mode
2, press +/- button to switch between ON/OFF, press UP/DOWN to choose the position, press +/- to change
value.
3, Press and hold Menu to exit or press menu to switch to next item
Caution:Elevator aileron, V tail mix, elevator mix can not be operated together at the
same time. Elevator, Flap aileron mix and aileron differential can only be operate
one function each time. WARN will be displayed when those are activated
together. Please turn off the rest before using it.
●Function description
Use this function to adjust the center point of flaperon aileron mix.
●Setting method
1, select FTRM 11 under setting mode
2, press +/- button to switch between ON/OFF, press UP/DOWN to choose the position, press +/- to change
value.
3, Press and hold Menu to exit or press menu to switch to next item
26
Airplane
Caution
To Next Page
Loading...
