WHEATON
®
Bench-Top Mini Bottle Roller Apparatus
9
WHEATON | 800.225.1437 (U.S. & Canada Only) | 856.825.1100 | www.wheaton.com | P/N 50075499 Rev. 10/2014 WMAN_026
OPERATION
Refer to Figure A
CAUTION: Keep hands and fingers away from rotating parts of the machine. Do not
remove any safety guards or operate the machine without the safety guards.
IMPORTANT: This apparatus was designed to run partially filled bottles for standard cell
culture applications. Please consult Wheaton engineering if you have special
applications.
1. Plug the unit into an appropriate source of AC power.
2. Place bottle(s) on unit.
3. Turn on the power switch located on the rear of the unit.
4. Adjust the speed control knob until the desired rotational speed is obtained. Turn the speed
control knob clockwise to increase roller speed, or counterclockwise to decrease roller
speed.
CAUTION: Because a fully loaded roller apparatus can become very heavy, care should
be taken when moving the equipment while it is loaded with bottles.
To Next Page
Loading...