INSTALLATIONINSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
Remove packaging materials
• Remove and dispose of/recycle packaging materials,
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers, Wipe with warm water
and dry.
• Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
Install Drain Hose
1. Remove drain cap from drain port.
Drain Cap
A A. Drain plug D. Clamps
B. Drain port E. Drain hose clip
B C. Drain hose
A. Drain port
B. Drain cap
2. Attach one end of the drain hose to the drain port with the
clamp. See Drain Hose graphic.
3. Insert the drain plug into the other end of the drain hose and
secure with clamp. See Drain Hose graphic.
4. Attach the drain hose clip to the back panel of the air
conditioner near the drain port with the screw provided.
Drain Hose Clip
"--------- B
A. Drain port
B. Attach drain hose clip with screw provided.
Install Exhaust Hose and Adapter
1. Roll air conditioner to its selected location. See "Location
Requirements."
2. Insert one end of the flexible exhaust hose into the exhaust
adapter.
3. Twist clockwise to lock hose into place.
4. Insert the other end of the flexible exhaust hose into the
window exhaust adapter.
5. Twist clockwise to lock hose into place.
A. Exhaust adapter
B. Flexible exhaust hose
B ..............
C
//'
C. Window exhaustadapter
To Next Page
Loading...
