What to do if my Whirlpool AS12 Air Conditioner is not cooling or heating air?
If your Whirlpool Air Conditioner isn't cooling or heating, check if the air filter is dirty, ensure that the air intakes and outlets are not blocked, and verify that the temperature is set correctly.
Why my Whirlpool AS12 Air Conditioner does not run?
If your Whirlpool Air Conditioner doesn't run, ensure the plug is properly inserted. Also, check the batteries in the remote controller. If everything seems fine, wait for 3 minutes before restarting, as the protector device might be preventing the unit from working.
Why does my Whirlpool AS12 Air Conditioner have a peculiar odor?
If you notice a peculiar odor from your Whirlpool Air Conditioner, it might be originating from another source like furniture or cigarette smoke. The unit could be sucking in these odors and blowing them out with the air.
Why do I hear a sound of flowing water in my Whirlpool Air Conditioner?
A sound of flowing water inside your Whirlpool Air Conditioner is caused by the flow of refrigerant and is not a cause for concern. It could also be defrosting sound in heating mode.
Why does my Whirlpool AS12 spray mist from the outlet?
Mist appearing from the outlet of your Whirlpool Air Conditioner occurs when the room air becomes very cold because of the cool air discharged from the indoor unit during COOLING or DRY operation mode.
Why is a cracking sound heard from my Whirlpool AS12?
The cracking sound you hear from your Whirlpool Air Conditioner may be generated by the expansion or contraction of the front panel due to temperature changes.
Instructions for setting the remote controller to Cooling Only or Heat Pump mode.
Interpretation of safety symbols and general warnings for safe appliance usage.
Analysis and solutions for common problems like no operation, poor cooling, or unusual sounds.
Detailed steps for purging air from refrigerant tubes using a vacuum pump.
Steps for installing the indoor unit mounting plate and drilling the wall hole for piping.
Instructions for indoor unit piping connection, insulation, and torque specifications.
Procedures for connecting power cables to units and relevant cable specifications.
Steps for outdoor unit installation, piping connection, and air purging.
General| Brand | Whirlpool |
|---|---|
| Model | AS12 |
| Category | Air Conditioner |
| Language | English |
To Next Page