What to do if my Whirlpool AE0789 Air Conditioner does not operate?
If your Whirlpool Air Conditioner doesn't operate at all, check the following: Is there a power failure? Is the plug properly inserted? Is the power fuse or switch off? Also, verify whether the voltage is too high or too low.
Why is the cooling efficiency not good in my Whirlpool AE0789?
If your Whirlpool Air Conditioner's cooling efficiency is not good, consider these possible causes: * Check if the air inlet or outlet is blocked. * Identify and eliminate any other heat sources in the room. * Clean the air filters if they are very dirty. * Ensure the indoor fan speed is not set to LOW. * If the room is too hot when starting the unit, allow some time to cool down the room.
Why is my Whirlpool AE0789 operation noisy?
If your Whirlpool Air Conditioner operation is noisy, there are a couple of reasons why: 1. A sound like water flowing indicates freon flowing inside the unit. 2. A sound like a shower indicates dehumidifying water being processed inside the unit.
Why does foggy air flow out of my Whirlpool Air Conditioner?
When operating in COOL mode, the foggy air flowing out of the indoor unit is due to the room's humid air cooling rapidly. The unit is normal while the indoor outlet is sending out some odor, because the inlet air may be mixed with the smell of furniture and smoke.
Why does my Whirlpool AE0789 Air Conditioner not operate for about 3 minutes when restarting?
This delay is a protective measure for the mechanism. Please wait approximately three minutes, and the Whirlpool Air Conditioner operation will begin automatically.
General| Brand | Whirlpool |
|---|---|
| Model | AE0789 |
| Category | Air Conditioner |
| Language | English |
Guidelines for optimal COOL and DRY mode operation based on outdoor temperature and humidity.
Essential electrical grounding, socket, and circuit protection requirements for safe operation.
Warning against self-installation and advice to use professional technicians for window type air conditioners.
Guide to operating the unit using the main control panel and thermostat.
Explanation of the remote controller's buttons and their functionalities.
Explanation of buttons like TIMER OFF, TIMER ON, FAN, SWING, and +/- for operation.
Detailed function of COOL, DRY, FAN SPEED, TEMP, and ON/OFF buttons on the remote.
Common fault phenomena like no operation, poor cooling, foggy air, and noisy operation with solutions.
To Next Page
