How to fix a Whirlpool Washer that won't turn on?
If the Whirlpool Washer does not turn on or the program won't start, make sure the plug is properly inserted into the electrical outlet. Also, check for a power failure and wait until power is restored. Ensure the lid is properly closed. To switch on the washing machine, turn the program selector first to “Off/O” and then to the desired program again.
Why is my Whirlpool Washer vibrating so much?
If your Whirlpool Washer is vibrating, it could be due to the washing machine not being level. Level the washing machine. Also, check if the transport bracket has been removed, as it must be removed before use.
What to do if the wash cycle won't start on my Whirlpool AWE7101N?
If the wash cycle does not start on your Whirlpool Washer, ensure that the “Start/Pause” button has been pressed. Also, check that the water tap is open.
Why does the 'No water' indicator light up on my Whirlpool AWE7101N Washer?
If the "No water" indicator lights up on your Whirlpool Washer, it means the appliance has no or insufficient water supply. Check the water supply to resolve this issue.
What to do if my Whirlpool Washer leaves clothes too wet after spin?
If your Whirlpool Washer's final spin results are poor and the laundry is still very wet, and the “Spin” indicator blinks, or the spin speed indicator blinks after the end of the programme, avoid small laundry loads if possible. Also, check if the “Spin” button has been set to a low spin speed and increase the spin speed if needed.
How to fix 'Water filter clogged' indicator on Whirlpool Washer?
If the "Water filter clogged" indicator lights up on your Whirlpool Washer, it means waste water is not being pumped out. Clean the water filter to resolve this.
Why does my Whirlpool AWE7101N stop mid-cycle?
If your Whirlpool Washer stops during the program and the “Start/ Pause” light blinks, the “Rinse hold” option might be activated. Deactivate the “Rinse hold” option. Alternatively, the program may have been changed. Reselect the desired program and press “Start/Pause”.
What to do if the 'Call Service' indicator lights up on my Whirlpool AWE7101N?
If the "Call Service" indicator lights up on your Whirlpool Washer, turn off the machine, disconnect the plug from the outlet, and wait about 1 minute before turning it back on. If the problem persists, you may need further assistance.
General| Loading type | Top loading |
|---|---|
| Maximum spin speed | 1000 rpm |
| Energy efficiency class | A+ |
| Number of Programs | 18 |
| Noise Level (Wash/Spin) | 76 dB |
| Dimensions (HxWxD) | 900 x 400 x 600 mm |
To Next Page