Why won't my Whirlpool AWM 6120 start, but the “Start/Pause” lamp is flashing?
If your Whirlpool Washer won't start but the “Start/Pause” lamp is flashing, verify that the appliance door is properly closed. Also, check to see if the program has been changed. Finally, ensure the water tap is open; if not, open it and press the “Start/Pause” button.
Why Whirlpool AWM 6120 will not start, and no lamp lights up?
If your Whirlpool Washer isn't starting and no lamps are lit, first, check to ensure the appliance is properly plugged in. Next, verify that the wall socket is working correctly by testing it with another device like a table lamp. Finally, ensure that a program is correctly selected.
What to do if my Whirlpool AWM 6120 has a water inlet fault (no or insufficient water supply)?
If your Whirlpool Washer shows a water inlet fault, ensure the water tap is fully open and the water supply pressure is adequate. Check the water inlet hose for any kinks. Also, inspect the mesh filters for blockages. Finally, make sure the water inlet hose isn't frozen.
Why is my Whirlpool Washer not draining properly?
If your Whirlpool Washer isn't draining correctly, check the drain hose for kinks. Also, inspect the pump and filter for any blockages. Finally, make sure the drain hose isn't frozen.
What should I do if my Whirlpool AWM 6120 displays an electrical module fault?
If your Whirlpool Washer shows an electrical module fault, switch off the appliance. Then, select a program and press the “Start/Pause” button again to continue the program.
What to do if my Whirlpool AWM 6120 stops during the programme?
If your Whirlpool Washer stops mid-cycle, make sure the “Rinse Hold” lamp isn't illuminated; if it is, turn off the option by pressing the button again. Also, check to see if another program has been selected; if so, reselect your desired program and press the “Start/Pause” button. Check whether the “Start/Pause” lamp is flashing and press the “Start/Pause” button. Finally, the safety system of the appliance may have been activated.
How to fix Whirlpool Washer that vibrates during the spin cycle?
To reduce vibration in your Whirlpool Washer during the spin cycle: * Ensure the appliance is level and firmly placed on all four feet. * Verify that the transit bolts have been removed before using the appliance.
What to do if final spin results are poor on my Whirlpool AWM 6120 Washer?
If your laundry is too wet after the spin cycle, try adding smaller items to balance the load and repeat the spin cycle. Also, make sure you're using the correct amount of detergent.
What causes detergent and additive product residues in dispenser at end of wash in Whirlpool AWM 6120 Washer?
If you find detergent and additive residues in the dispenser after a wash, ensure the siphon is correctly installed and clean. Also, check that enough water is being supplied; the mesh filters between the inlet hose and the tap could be blocked.
General| Brand | Whirlpool |
|---|---|
| Model | AWM 6120 |
| Loading Type | Front Loading |
| Load Capacity | 6 kg |
| Spin Speed | 1200 RPM |
| Energy Efficiency Class | A |
| Dimensions (H x W x D) | 85 x 60 x 54 cm |
| Color | White |
| Control Type | Electronic |
| Display | LED |
| Child Lock | Yes |
| Delay Start | Yes |
| Quick Wash | Yes |
| Drum Material | Stainless Steel |
| Wash Programs | Cotton, Synthetics, Delicate, Wool, Quick Wash |
| Water Consumption | 49 L |
| Type | Washing Machine |
To Next Page
