User manual
11
DISPLAY INDICATORS
Door locked
This indicator will light up
• after you have started a programme
• the porthole door is locked
FreshCare+
This indicator will light up
• after you press Freshcare+ button
Start delay
This indicator will light up
• after you press Start delay button
Key lock
This indicator will light up
• after you press Key lock button
Washing phase
indicator
This indicator shows the current programme phase, running from left
to right through wash, rinse and drain. The illuminated indicator light
shows which phase is in progress.
Call Service
Failure: Call After-sales service
• Refer to Troubleshooting section
• If the indicator persist, call After-sales service
Water lter
clogged
Failure: Water lter clogged
• Water cannot be drained; water lter might be blocked
No water
Failure: No water
• No or not sucient inlet water.
HINTS AND TIPS
RULES FOR SEPARATING LAUNDRY
• Fabric type / indications on label (cotton, mixed bres,
synthetic, wool, handwash items)
• Colour (separate coloured garments from whites, wash
new coloured items separately)
• Size (wash items of dierent sizes in the same load to
improve washing ecacy and weight distribution in the
drum)
• Delicates (place small items – such as nylon stockings –
and garments with clasps – such as braziers – in a laundry
bag or in a pillow case with a zip).
WASH SYMBOLS ON GARMENT LABELS
The value given in the tub symbol is the maximum
temperature possible for washing the garment.
Normal mechanical action
Reduced mechanical action
Much reduced mechanical action
Hand wash only
Do not wash
CLEAN THE WATER FILTER REGULARLY
• This is needed to prevent the lter from blocking and
preventing the water from draining correctly.
SAVING ENERGY AND PROTECTING THE
ENVIRONMENT
• Keeping within the load limits indicated in the
“PROGRAMM CHART” will optimise energy, water and
detergent consumption and reduce washing times.
• Do not exceed the detergent quantities recommended by
the detergent manufacturer.
• Save energy by using a 60 °C instead of a 90 °C wash
programme, or by using a 40 °C instead of a 60 °C wash
programme. We recommend using the “ Cotton " the
60 °C programme for cotton garments, which is longer,
but uses less energy.
• To save energy and time when washing, select highest
spin speed available for the programme to reduce the
residual water remaining in the garments at the end of the
wash cycle.
• Pretreat any stains with an appropriate stain remover,
or else dampen any dried-on stains with water prior
to washing, as this will reduce the need to use a high
temperature wash programme.
• Use the “Colours 15°” programme for lightly soiled
coloured garments; this will reduce the amount of energy
used to heat the water.
To Next Page
Loading...
Need help?
General
