©Service Competence Center
Installation
Electrical connection
Induction Oven
ELECTRICAL CONNECTION (only in some models)
Make sure the power voltage specified on the appliance data plate is the same
as the mains voltage. The data plate is on the front edge of the oven (visible
when the door is open).
-F 3 x 1.5 mm2) must be carried out
by a qualified electrician. Contact an authorized service centre.
(indicated by "HIGH" in the settings) which is compatible with a domestic
power supply above 3kW. If the household has a lower power supply, the
setting must be lowered ("LOW" in the settings). The table below details the
recommended electrical power settings for the various countries.
To Next Page
Loading...
